Sheepskin car seats offer outstanding comfort because they are warm in the winter and cool in the summer, thanks to the breathing properties of wool's hollow fibers. The comfort level is very high because the fabric is extremely soft and provides a comfortable cushion of air that acts as an insulator.

While your sheepskin car seats are protecting you, they also increase the salvage value of your car by protecting your expensive upholstery from wear and tear, as well as fading. The natural lanolin in sheepskin will increase the durability of leather seats over time, turning sheepskin seat covers into a great investment.

Ok, let's now look at the installation process. The following instructions apply to all vehicles. Then, we will look at the slight variations required if you have adjustable headrests.

First, start by pulling the seat cover over the shoulder of the seat. Smooth out the sides and backrest of the seat and make sure the cover is centered. Then, push the center straps through space between backrest and seat cushion. At the same time reach around and pull the straps through. This can be facilitated by either tilting seat backrest to increase the space or by kneeling on cushion.

Next, from the back seat area, you should pull center straps and hook them to the underside of the seat. This hook can be fastened to the springs or any metal edges, wire, etc. Do not use the electrical wires or the sliding track of seat to fasten the hooks. Then, you need to attach the straps. Look for anchor spots then keep your head well out of the way when pulling and fastening straps or else you could get hurt by a sudden release of the straps.

If your vehicle is a two door model, in other words the seats move forward to access the back, then leave enough slack for the seat to move. If the straps are too tight, they will break when the seat is moved forward. Should that happen, the manufacturer will likely not assume any responsibility for damage.

We are down to the last few steps in installing the sheepskin car seats. Push the side straps through center at each side of the seat. Pull down and back, hooking to the underside of the seat. Do not put straps in the way of the sliding tracks. Then, pull the seat cover forward and smooth it out over the seat cushions and the sides. Pull the straps at front and hook to underside of the seat. Also note that when hooking straps to the underside of the seat, you may have better access by moving the seat forward, back or up.

Finally, sit on the sheepskin car seats to make sure cover has assumed proper position on the seat.

Most vehicles will have removable headrests on the seat and can be easily removed for installation. Once the cover is installed, make a small cut With a sharp knife to put the headrest back into place. This can be done from sitting in the back of the seat. Line up the knife with the headrest holes in the seat and then lift up the sheepskin away from the seat and cut the holes. Make sure you cut through the sheepskin and lining. There you go! You now have great sheepskin car seats in your vehicle!